Waissi Engine Update: The Differences Between Waissi and Bourke Engines

Bourke Engine (click for animation) In a comment to my post last month about Professor Gary Waissi's new piston engine that has no connecting rods between the pistons and the crankshaft, one of our readers asked about similarities to the Bourke Engine, invented by Russell Bourke. Based on the diagrams of the Bourke motor, that seemed like a good question, so I asked Prof. Waissi about it. I received his reply today. Waissi said that while there were similarities between his engine and Bourke's, there were also substantial differences, resulting in the Bourke engine having more operating friction. Dr. Waissi also said that he hoped to have a two-cylinder prototype of his own design assembled and running by the end of this year. Waissi's response after the jump. Click here to view the embedded video. Thank you for the message, and for writing the article. I am very familiar with the Bourke engine and concept; a Scotch Yoke engine. A number of similarities, including aligned cylinders, and connected piston structure. The main difference is, as clearly shown in the animation, that the Bourke Engine uses a "conventional" crankshaft with "yoke". There is no "yoke" in the Waissi Engine, because the crankshaft is like a camshaft (a straight shaft). The Bourke engine does also not use hydrodynamic lubrication in-between the bearing rings, which does not, in my estimation, reduce the friction, but increases it. Both engines, the Bourke and the Waissi Engine, have only primary piston forces (because of no piston rods), and therefore are simpler to balance.  In the Waissi Engine design the crankshaft is actually like a camshaft — a straight shaft; and an off-set camdisk, and a hydrodynamically lubricated bearing ring. The bearing ring has a significantly larger surface area (between the inside surface of the ring and the disk outer perimeter) distributing the piston force to a larger area resulting into a lower bearing pressure. Another advantage of the Waissi Engine is manufacturability — straight shaft vs. crankshaft — especially with multi-cylinder engines; you can use the same cam(crank)shaft for engines with different piston strokes, by just changing the disk (as the stroke depends on the disk off-set). For example in an F-1 engine the stroke is 40 mm; andf for "regular" engines the stroke varies widely (60- 70- 80- 90- 100 mm). With regular engine designs, including the Bourke engine, for every variation you need a new crankshaft. With the Waissi Engine from a F-1 engine to a pick-up truck engine you need just one. I am currently working on a two-cylinder version of the Waissi Engine. My plan includes to get a testable version running before the end of the year. (A two-cylinder version, because it is cheaper to build). Ronnie Schreiber edits Cars In Depth, a realistic perspective on cars & car culture and the original 3D car site. If you found this post worthwhile, you can dig deeper at Cars In Depth. If the 3D thing freaks you out, don't worry, all the photo and video players in use at the site have mono options. Thanks for reading – RJS from The Truth About Cars http://www.thetruthaboutcars.com

Put the internet to work for you. via Personal Recipe 680102